Easy coding of your new remote control

1. Place the transmitter that is to teach the code (teaching transmitter) and the transmitter that is to learn the code (learning transmitter) directly next to one another.

2. Press and hold the designated button on the teaching transmitter. The LED will then light up and remain lit.

3. Press and hold the designated button on the learning transmitter immediately afterwards - the LED on the learning transmitter will flash slowly for 4 seconds and begin to flash quicker when the learning routine was successful.

4. Release the buttons on both transmitters. Do a function test! If the transmitter does not function correctly, repeat steps 1 - 4.

Pressing a button on the teaching transmitter during the learning routine may cause the door to move if the receiver programmed to trip the door is located in the near vicinity!

Zuletzt aktualisiert am 2012-11-28 von Daniel Scheurich.

Zurück

Einen Kommentar schreiben